LCD operator unit in accessories for controller of fans Rosenberg
Used on controller Airtronic D/Basic
The LCD operator unit permits reading off and altering of the functional parameters of the controller. It consists of a keyboard and a display in an enclosure.
Display: 4x20mm (height of characters 5mm) backlit
Keyboard: 5 transparent, lit silicon rubber keys
Colour: Grey
Dimensions: 297.5 x 107 mm
And is connected with a 6-line telephone cable to the base circuit board via an RJ45 plug.
Operator station RTE/D..TR; MSD..TR in accessories for controller of fans Rosenberg
Used with controller:
RTE/D..TR and MSD..TR
Suitable as a remote operator station for adjusting set points in living rooms, offices etc.
- Changing the room temperature set point with potentiometer
- Changing the operating status (ON/OFF) by switch
No temperature measurement can be taken, so only inlet air control possible
Type of protection: IP 20
Enclosure: WRF02, material ABS,
Dimensions: 84x84x22mm colour white; connection via 4-pole terminal
Master switch in accessories for controller of fans Rosenberg
Used with controller RTE/D..TR, MSD..TR and Airtronic D/Basic as master
Switch
- Designed for fitting into switch box
5-step speed control switch 230 V in accessories for controller of fans Rosenberg
Used on controller RTE/D..TR, MSD..TR with 230V single-phase setup
- On/Off switching of the system
- Switching the fan's 5 voltage steps
- Designed for fitting into switch box
5-step speed control switch 400 V in accessories for controller of fans Rosenberg
Used with controller RTD..TR, MSD..TR with 400V three-phase current setup
- On/Off switching of the system
- Switching the fan's 5 voltage steps
- Designed for fitting into switch box
Control transformer 24V in accessories for controller of fans Rosenberg
Used with controller RTE/D..TR, MSD..TR and Airtronic D/Basic
Primary: 230V / 400V AC 50/60 Hz 0.28 / 0.16A
Secondary: 24V , 2.08A
The control transformer is used with all controllers as a transformer for the 24V control voltage
PTC resistor activation device TÜS 100a in accessories for controller of fans Rosenberg
Used with controller RTE/D..TR, MSD..TR and Airtronic D/Basic as PTC resistor activation device for fitting into the switch box for motors with PTC resistor protection.
- Max connection of 6 PTC resistors in series
- Mounting rail assembly
Timer switch in accessories for controller of fans Rosenberg
Used with controller RTE/D..TR, MSD..TR
The electronic timer switch is used for automatic turning on/off of the system.
Measurements (HxWxD) 45 x 36 x 60
Connection: 230 V AC 50/60 Hz
Breaking capacity: 16A/250V AC (load, ohms)
2.5A/250V AC (inductive load)
Switch output: potential free
Switch contacts: 1 changeover contact (option: 2 changeover contacts)
Running accuracy: +/- 2.5 sec/day at +20°C
Reserve power type: Lithium battery
Power reserve: 3 years from leaving factory
Shortest switch time: 1 minute
Programmable: Every minute
Memory locations: 20
Manual switch: Automatic/fixed pre-selection
On/Off
Switch status indicator: yes
Summer/ winter time settings: automatic/freely selectable
Protection class/type of protection: IP 20
Assembly: DIN mounting rail
The contact addresses are to be found in the attachment, or else please phone +49 (0)7940 / 0917 186 894 or email to info@rosenberg.com.vn